IRB enables you to route packets to another routed interface or to another bridge domain that has a Layer 3 protocol configured Note.
#Flow free bridges pc how to#
This document describes how to understand and troubleshoot the Bridge Virtual Interface (BVI) and the Bridge Domain Interface (BDI).
1D bridge I read that bridge domain is used to bundle one or more L2 interfaces to a 元 logical interface. In this case the "Reject" statement as next-hop means that for traffic who's destination is this IP address, router will generate "icmp unreachable". In doing so, a group of switched interfaces is created.
The net effect is similar to the members being connected to the same layer 2 or switch. So here's how to configure dnsmasq be a better DHCP (and DNS) server.is that correct? pls clarify providing a real life example thanks Enterprise Certifications What is bridge domain Cisco? “Bridge domain interface is a logical interface that allows bidirectional flow of traffic between a Layer 2 bridged network and a Layer 3 routed network Bridge domain interface is a logical interface that allows bidirectional flow of traffic between a Layer 2 bridged network and a Layer 3 routed network traffic. Bridging domains forward packets based on VLAN ID. The bridge is a logical interface with a MAC address and an MTU (maximum transmission unit). Ethernet bridges enable hosts to communicate through layer 2 by connecting all of the physical and logical interfaces in the system into a single layer 2 domain. Bridge domain and a VPLS instance Only one logical tunnel (physical interface) per bandwidth type (1 Gbps or 10 Gbps) can be configured on ACX routers. Assign IP addresses from the same network to PC1 and PC2 and test. The command cannot be used on other modules or on Gigabit Ethernet (GE) LAN interfaces.
0 kommentar(er)
